Disposable cutlery can be said to be a just-needed product in the food delivery industry, which consumes a lot of money every day. Long-term use of the Injection molding machine for cutlery, without regular maintenance and maintenance, our injection molding machine may malfunction, such as temperature rise. This article will tell you about these hazards.

📣Hazard #1 thermal deformation of the machine

The moving parts with different coefficients of thermal expansion in the gas elements are actually stuck due to their much smaller matches, resulting in breakdowns, impacting the gear box reliability of the hydraulic body, as well as weakening the working high quality of the components.

📣Hazard # 2 decrease the thickness of the oil

Extreme temperature level increase of the treatment molding machine will definitely cause the viscosity of the oil to lessen, boost the leak, and also the volumetric effectiveness of the pump and also the performance of the whole entire unit will be significantly reduced. As the thickness of the oil minimizes, the oil layer of the moving shutoff as well as other moving components ends up being thinner as well as decrease, and the frictional protection rises, resulting in increased wear.

📣Hazard # 3 deformation of rubber tapes

Extreme temperature level increase of the shot creating equipment will warp the rubber tapes, increase the getting older breakdown, lessen the sealing performance and service life, as well as cause leak.

📣Hazard # 4 accelerate the oxidation as well as deterioration of oil

Too much temp ascent of the injection molding device will definitely increase the oxidation and also destruction of the oil, speed up bituminous substances, and lower the service life of the hydraulic oil. The precipitates shut out the damping window and the slit valve slot, inducing the pressure valve to come to be caught and also unable to relocate, and the steel water pipes is actually flexed and also angled, or even ruptured.

📣Hazard # 5 leading to bad work quality of components

Extreme temperature level increase of the injection creating equipment are going to lead to unsatisfactory functioning quality of the components, and also the diffused sky in the oil will certainly get away, leading to sky pockets, which will lower the working efficiency of the hydraulic device.

The perfect working temperature of the hydraulic system must be in between 45 degrees as well as 50 degrees. The reason is actually that the gas unit is developed depending on to a chosen tension oil thickness, but the thickness is going to modify with the oil temperature, which will have an effect on the function in the system. Parts, such as oil cylinders, gas shutoffs, etc, reduce management precision and feedback sensitiveness, especially for precision injection makers.

Simultaneously, if the temp is actually too high, it will increase the getting older of the seal and cause it to harden as well as split; if the temperature is actually too low, the handling power will definitely be actually eaten as well as the functioning velocity will definitely be reduced. For that reason, it is actually required to spend close attention to the functioning temperature of gas oil. There are actually several explanations for the higher oil temperature, but most of all of them are due to the failing of the oil circuit or even the failing of the cooling unit.

Method of expressive temp rise of injection creating machine

1. According to various bunch demands, consistently check out and also readjust the tension of the overflow valve to make it ideal.

2. Sensibly decide on gas oil, especially the oil thickness. When problems enable, attempt to utilize a lesser viscosity to reduce viscosity friction loss.

3. Boost the lubrication conditions of relocating components to lower rubbing reduction, which is conducive to reducing work load as well as home heating.

4. Strengthen the assembly quality and also accuracy of gas parts and hydraulic bodies, stringently handle the healthy space of the matching components as well as strengthen the lubrication ailments. Making use of securing components along with a little rubbing coefficient and also strengthened securing construct to reduce the starting power of the gas cylinder as much as achievable to lower the heat energy produced by the mechanical friction reduction.

5. Add an air conditioning gadget when necessary.

If your injection molding machine is damaged due to long-term use without maintenance, you have to buy bulk injection molding machine for cutlery, you can find them on our website. If you are interested, you can get in touch with us through the contact information at the bottom of this page.