The plastic bucket made by the injection molding machine is definitely a must-have tool at home. It can not only take in water when there is no water, but also can hold some aquatic food. You may be wondering what is a injection mold machine for plastic bucket? Let’s discuss it together.

injection mold machine for plastic bucket -- Lisong 

The injection machine is a device that integrates hydraulic, electrical, mechanical and other technologies. With the maturity and development of various technologies, the combination of the three becomes closer. Refer to how to maintain the injection mold machine for plastic bucket , let's start with the electrical.

Wire connector inspection

Unfastened wires in the connector will cause high temperature or spark damage to the connector position. A poor connector will also affect the signal transmission; the connector on the contactor will be easier to loose due to the vibration of the electromagnetic action, so it is necessary to check the wire connector regularly Position and tighten.

Motor

Generally, motors are air-cooled, and the accumulation of dust causes difficulty in heat dissipation, so regular cleaning is done every year. Usually, a motor overload cut-off device is installed in the circuit. The limit current of the protection device is adjustable. It should be appropriately selected according to the electric power. At the same time, once the overload protector is activated, it should be determined to check whether there is phase loss, bad contact or oil temperature. Press the return position switch only after it is too high.

Heating cylinder and thermocouple

The heating cylinder should be regularly checked for tightening to ensure effective heat transfer. It is not easy to notice that the heating cylinder is hungry and burnt during normal production. For this reason, pay attention to the working condition of the thermostat and judge whether the heating cylinder is normal. In addition, the common damage of the heating cylinder is the wire connection. Due to the poor joint, the contact resistance increases, and the local overheating of the connection causes the interface to be oxidized and damaged.　

Electromagnetic contactor

Since the contactor of the electric heating part has frequent movement, its loss rate is also faster, if the main computer control part that are bonded may cause heating temperature out of control, so if the contact is found to be overheating, sound or section spark is very large, it will be damaged, should be replaced as soon as possible. Therefore, if you find that there is overheating in contact, noise or large sparks when segmented, it means that it will be damaged and should be replaced as soon as possible.

Computer control part

With the application of microcomputer control technology to the injection machine, the normal operation of the microcomputer part and its related auxiliary electronic board has brought forward the fluctuation of the power supply voltage, the temperature and humidity of the working environment, the shock resistance of the installation and the interference of external high-frequency signals. Higher requirements, to maintain the normal operation of the fan for ventilation and heat dissipation in the control box, use high-precision power supply and stabilizer equipment to supply power; try to reduce the control box from external vibration (micro potentiometer is most susceptible to vibration), etc. These are the basic requirements for normal work, and these problems should be solved and checked regularly.

Final words

Plastic chairs are particularly in demand, so keeping injection machine in a good condition is extremely important thing. Daily maintenance is needed. We are bulk customized wholesale buy high quality injection mold machine for plastic bucket wholesaler, manufacturer, supplier, factory, exporter for sale, welcome to contact us for more information.